[. . . ] ® Power for the Digital Revolution. ® HTFS 2 FLOOR STANDS OWNER'S MANUAL INTRODUCTION Introduction Thank you for purchasing Harman Kardon HTFS 2 floor stands. [. . . ] The mounting plate tab with the third screw hole should sit on the higher rim of the column. Attaching the Speaker to the Stand 1. Unscrew the bolt that attaches the black shelf stand to the bottom of the speaker. Store the stand in a safe place in case it is needed for a future installation. The bolt will be used to attach the speaker to the floor stand mounting plate. Place rubber pads or floor spikes here Remove Stand 2. If you will be using the HTFS 2 stands on a carpeted surface, screw four of the supplied floor spikes into the base using the threaded inserts in the recesses as shown in the drawing. Following the instructions on pages 9 through 12 of the owner's manual provided with your HKTS system, thread the appropriate speaker cable through the hole in the center of the base, being careful to avoid the two screw holes. Then feed the cable through the length of the column from the bottom until it comes out the top. Thread the speaker cable through the hole in the center of the mounting plate, being careful to avoid the three screw holes. 15mm or 1/2" 2. [. . . ] Harman Kardon and Power for the Digital Revolution are registered trademarks of Harman International Industries, Incorporated. ® 250 Crossways Park Drive, Woodbury, New York 11797 516. 255. HKHK (4545) Fax: 516. 682. 3523 © 2003 Harman International Industries, Incorporated Part No. [. . . ]